Gp Command - Access The Current Configuration Of The Sp Command - Baumer VeriSens ID Series Technical Documentation Manual

15.4.9 GP command – access the current configuration of the SP command
This function allows you to read out the current values that can be changed using the SP command (set
parameters for feature checks).
This is useful, for example, if you wish to read out the expected value for the "Barcode" / "Matrix code" via
the controller.
Example
Structure of the command PLC
Command Parameters
G P
Get none
Parameter
Structure of the Response PLC
Response
R G 0
Response 4 byte ASCII hex
Get
Parameter Length of the result data
NOTE
You can set the content of the datagram for output via the process interface during job
creation under Configure interfaces → Output process interface.
v2.11.0-B4
device
device
0 0 8 1
Data
The content of the data corresponds
with the expected values currently
set for the feature check
e.g. a date, or a combination of
expected values for different feature
checks and display settings.
5 . 0 2 .
316/429
Technical Documentation
VeriSens
1 4
Baumer Optronic GmbH
Radeberg, Germany
®