Ip Protection Classes - Baumer VeriSens ID Series Technical Documentation Manual

6.3 IP protection classes

The devices continue working in an industrial environment to meet the requirements of various protection
classes.
IP protection classes
IP 67 (all devices)
IP 69K (only stainless
steel)
ATTENTION!
The respective IP protection class is only valid if all connectors are connected as
described in the technical documentation and, for devices with protection class IP 69K, if
the sealing screw on the lens setting opening is correctly screwed in.
A protective cap must be installed on unused electrical screw connections. The use of the
following protective caps is recommended:


The electrical hose connections on the device must be tightened with a torque of 0.4 Nm.
The tube on devices with replaceable lens must be screwed without a gap as depicted in the figure below in
order to achieve the stated protection class.
v2.11.0-B4
Sealed against dust, protection against short-term submersion
Sealed against dust, protection against jets of water. Although you should avoid
cleaning with a pressure washer.
Connector M8 Cover IP67, Phoenix Contact, PROT-M8, order no.: 1682540
Ethernet connector M12 Cover IP67, Franz Binder GmbH & Co.,
order no.: 08 2769 000 000
21/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®