Baumer VeriSens ID Series Technical Documentation Manual page 64


Contrast: Set the minimum contrast of the contours that should be adopted in the model.

Form: Select the shape of the contour that corresponds to the test object and that should be
adopted in the model. (Limiting the angular range reduces processing time.)

Mode: Set the amount of detail to be used in the inspection. (The more detailed the mode, the
higher the processing time.)

Max. rotation: If you want to find the object only in a limited angular range, you may specify the
maximum rotational position here.

If you do not wish to search for the object in the entire image, set the tick and then limit the detection
area.
Model editor tab

With the displayed model, you can now use the mouse to delete contour points which clearly do not
belong to the reference object.

Use this button to restore the model to its original state.

You can use these two buttons to enlarge or reduce the model.

Confirm your settings and return to the feature list with OK. Return to the feature list without making
any changes with Cancel.
Feature check Brightness
This sensor task measures the mean brightness in a field of view and compares the result with the specified
switching points.
This feature check supports external Teach. The switching points are adjusted as an absolute to the current
measured value.
v2.11.0-B4 64/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®