Sj Command - Change To A Different Job - Baumer VeriSens ID Series Technical Documentation Manual

15.4.12 SJ command – change to a different job
This function enables you to change to a different job.
To use this function, you must first activate the option Command SJ via process interface in the device
settings.
Example
Structure of the command PLC
Command Parameters
S J 0
Switch Job
4 byte ASCII hex
desired job number
Structure of the Response PLC
Response
R S 0
Response 4 byte ASCII hex
State Status
NOTE
Further explanation of the parameters of the RS response can be found under "Request
status (GS / RS)".
v2.11.0-B4
device
0 1 A
device
0 8 5
4 byte ASCII hex
Number of the active job
0 0 1 A
320/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®