Baumer VeriSens ID Series Technical Documentation Manual page 12

Technical Documentation
®
VeriSens
ATTENTION!
The device may become very warm during operation. High temperatures may damage the
device. Ensure that any heat generated is dispersed by installing it with the rear to a good
heat conductor (aluminium).
Direct mounting on a solid metal (aluminium) object without using a retaining bracket is
required when operated in the limit zone (e.g. full load on the flash controller and
utilisation of the maximum operating temperature)!
For devices with integrated Industrial Ethernet only:
These devices are equipped with an internal temperature monitor for built-in protection.
There may be a warning message or emergency shutdown if the device is operated
outside its specified range.
ATTENTION!
Incorrect supply voltage will destroy the device!
Pin 1: Power ( 24 V ± 25 %)
Pin 2: Ground
ATTENTION!
The device can become damaged by strong radiation or electrical fields.
For this reason, never place the device near strong radiation sources or strong electrical
fields. These can occur in close proximity to lasers, for example.
ATTENTION!
The Vision Sensor is a class A device (DIN EN 55022:2011). It can cause radio
interference in residential environments. Should this happen, you must take reasonable
measures to eliminate the interference.
WARNING!
The device emits bright, pulsed light (Risk group 1, low risk, EN 62471:2008).
Bright, pulsed light can cause damage to the eyes and seizures.
Never look directly into the pulsed light from the LEDs!
v2.11.0-B4 12/429 Baumer Optronic GmbH
Radeberg, Germany