Baumer VeriSens ID Series Technical Documentation Manual page 359

5. Configure the data structure to be transmitted.
You can connect up to four modules. These
modules must be plugged into certain,
predefined slots:
Slots Module
1 Control and status
2 Result data (selection of the user
data size)
3 Parameters (selection of the user
data size)
4 Trigger data (selection of the user
data size)
You can leave out individual modules. For example, only the control and status module and the result data
module may be connected.
6. Configure the correct data input / output
address range in the PLC process map.

The Vision Sensor has now been installed.
7. The project has to be compiled to test data
transmission.
Click on the corresponding icon to do this.
v2.11.0-B4 359/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®