Baumer VeriSens ID Series Technical Documentation Manual page 48

(device dependant)
Click on Configure external illumination... to make the settings for a connected external illumination system
or a flash controller.
(device dependant)
You can choose between two resolutions for the device, for the reduced resolution, additional profiles
optimised for speed or brightness are available.
NOTE
The reduced setting will always detect 2 x 2 pixels and only one in four pixels will be read
out. By using the "Reduced, max. speed" setting, the image acquisition time is reduced.
By using the "Reduced, max. brightness" setting, a much brighter image can be acquired
with the same length of exposure.
This is particularly useful with fast moving objects. Choose the mode in which the feature
to be checked appears most clearly. Due to the smaller image size, image processing will
generally be faster in both cases.
With the illumination settings, you can switch off the internal illumination and possibly activate external
illumination with the Flash sync output. If you wish to use the external Flash sync output, this must be
chosen accordingly in the Digital I/O menu. You can also activate both type of illumination.
The Flash Sync Signal is located parallel to the exposure time on the digital I/Os. The exception to this is the
4-pin connection on devices with interchangeable lenses. Here the signal is available at a maximum of 1
metre per second if the operating mode Activate external flash controller (max. 1 ms) is selected.
v2.11.0-B4 48/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®