Sp Command - Set Parameters For The Feature Checks - Baumer VeriSens ID Series Technical Documentation Manual

15.4.14 SP command – set parameters for the feature checks
With this function, you can adjust the expected values of the feature checks as well as adjust the parameters
of the image settings such as exposure time, amplification, edge sharpness, trigger mode and trigger delay.
The expected values are set temporarily and remain valid until the device is restarted or switches to
configuration mode.
To save it long term, activate: Device → Device settings→ Job selection / Teach → Save changed
parameters from external Teach or process interface command XX to device...
NOTE
You can set the content of the datagram for output via the process interface during job
creation under Configure interface → Output process interface.
NOTE
When setting the exposure time for the job, the "Camera ready" signal must be active
before the next image can be acquired.
v2.11.0-B4 323/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®