Installing And Commissioning The Vision Sensor - Baumer VeriSens ID Series Technical Documentation Manual

16.3.3 Installing and commissioning the vision sensor

To install the vision sensor, follow the instructions in Chapter:
The vision sensor, the PC with the Application Suite and the UR robot controller must all be in the same
subnetwork, e.g. connected by a hub or switch.
Number Description
UR robot controller
1
(For Setup see PolyScope Technical Documentation)
Vision sensor
2
To set up the network connection, see Chapter:
PC with Application Suite
3
To set up the network connection, see Chapter:
computer
Switch / hub
4
v2.11.0-B4
Installation and initial
IP address / network
Initial set-up of the Ethernet interface on your
393/429
Technical Documentation
VeriSens
set-up.
Baumer Optronic GmbH
Radeberg, Germany
®