Sm Command - Change Operating Mode - Baumer VeriSens ID Series Technical Documentation Manual

15.4.13 SM command – change operating mode
This command enables you to change the operating mode for the device as well as the parameters for data
exchange.
Example
Structure of the command PLC
Command Parameters
S M M
Switch 2 byte ASCII hex
Mode
Mode
DC = Data transfer – Continuous Mode
The result data is autonomously transferred via the process interface after
each analysis in Activated mode. You must also set the "Activate outputs"
parameter during job testing.
DP = Data transfer – Polling Mode
In Activated mode and in Configuration mode, the result data is only
transferred after the GD command has been received.
MR = Mode switch – Modus Run
The device is activated.
Data is only transferred autonomously if the Continuous mode is activated
as described above.
MS = Mode switch – Modus Parametrieren
The device is switched to Configuration
No result data is transferred.
For Ethernet only
CC = Command delimiter – Carriage return
Data packets from the process interface are terminated using <CR>
(Hex: 0D, Escape sequence: \r) complete
CL = Command delimiter – Line feed
Data packets from the process interface are terminated using <LF>
(Hex: 0A, Escape sequence: \n) complete
CB = Command delimiter – Both carriage return + line feed
Data packets from the process interface are terminated using <CR><LF>
CN = Command delimiter – No sequence
Data packets from the process interface are not terminated using a
sequence
v2.11.0-B4
device
R
321/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®