Installation And Initial Set-Up; Mechanical Set-Up (Image) - Baumer VeriSens ID Series Technical Documentation Manual

6 Installation and initial set-up

6.1 Mechanical
set-up (image)
You can operate the device in any position.
Attach the device to the M4 screws provided for this purpose.
Align the device so that the image centre indicated below points directly at the object to be inspected.
The device should be installed so that it vibrates as little as possible during operation to avoid negative
influences on the image quality (blurred images).
Install the device so that there are no obstacles between the sensor and the object that could block the view
or cause reflections. Ensure that the device is protected as well as possible against dust.
Devices and its built-in lens can inspect fixed areas at fixed distances.
NOTE
The field of view and minimum module size for devices with interchangeable lenses
depends on the lens installed.
v2.11.0-B4 17/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®