Baumer VeriSens ID Series Technical Documentation Manual page 216


Now select Add on the colour palette to teach in the first target colour to be counted.

In the next step, mark the first target colour to be added on the image. This target colour can be
located in any part of the image area and does not have to be in the detection area. However, only
target colours in the defined detection area are counted. The marked target colours are displayed
with a hatched pattern in the detection area.

You can add up to 8 target colours to the colour palette. With Add (auto), an area is automatically
suggested for you to add as a new colour. Move the suggested area to the desired area and adjust
its size if necessary.
3D>>: Here you can see where the defined colours are in a CIELab colour coordinate system. Unlike
the CIELab colour coordinate system on the Colour parameters tab, the complete colour area is
displayed and is not limited to 50 values per axis. The current target colour is marked with a grid.
Only colour areas that do not overlap can be definitively detected.

The current result is displayed directly in the dialog as the Number of areas. The switching points
designated Min and Max are adjusted on the right hand side. A graphic display is located in the
middle, in which the positions of the switching points are displayed and where they can be changed.

The right button is used to invert the result of the feature check.
v2.11.0-B4 216/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®