Baumer VeriSens ID Series Technical Documentation Manual page 156


Contrast: Set the minimum contrast of the contours that should be adopted in the model.

Form: Select the shape of the contour that corresponds to the test object and that should be
adopted in the model.

Mode: Set the amount of detail to be used in the inspection. (The more detailed the mode, the
higher the processing time.)

Max. rotation: If you want to find the object only in a limited angular range, you may specify the
maximum rotational position here. (Limiting the angular range reduces processing time.)

If you do not wish to search for the object in the entire image, set the tick and then limit the detection
area.
Model editor tab

You can use these two buttons to enlarge or reduce the model.

You can gradually undo or redo the changes using these buttons.

With the displayed model, you can use the mouse to delete contours which clearly do not belong to
the reference object. Select the required tool strength to do this.
v2.11.0-B4 156/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®