Safety Instructions - Baumer VeriSens ID Series Technical Documentation Manual

3 Safety instructions

Explanations of safety instructions
NOTE
Gives helpful notes on operation or other general recommendations.
ATTENTION!
Indicates a possibly dangerous situation. If this is not avoided,
slight or minor injury could result or the device may be damaged.
WARNING!
Indicates an immediate imminent danger. If this is not avoided, death or serious injury
may occur.
General notes / Safety instructions for the Vision Sensor
NOTE
There is a scratch-resistant foil on the glass cover of the tube for devices with
interchangeable lenses. Remove the foil before carrying out inspection tasks.
NOTE
For UL-compliant installations, the cables used must meet the following requirements:






v2.11.0-B4
Shielding for optimum interference immunity
IP67 protection
UL approval
Dielectric strength in line with the operating voltages used
Temperature resistance in the specified device temperature range
Minimum cross-section of the cable in line with the max. output current
10/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®