Job Features - Baumer VeriSens ID Series Technical Documentation Manual

8.4 Job features

The Application Suite helps you to create, manage and test jobs and to configure them for operation.
Each inspection task is processed by the device in the course of a job. For each job required an image will
be acquired in which you mark the features to be checked. A pass/fail result will then be determined.
The following individual steps are used to create a job:
1. Adjusting the image: Each inspection with the device is based on image data. The image quality
depends on the internal camera settings, the illumination settings and lens adjustments. Here, you
can set all parameters concerned with the primary image acquisition and its control.
2. Checking features: Checking the features is the actual evaluation. Each feature check operates in
a field of view, determines one or more values and compares the result with preset switching points.
In a second step, you can link the results of the sensor tasks to produce a result.
3. Configure interface I/Os: This includes settings for digital outputs (output time and duration of
output, among other settings) and configuration for datagrams of the process interface.
You can also set which feature checks and their functions can be operated via the web interface.
This information is saved separately for each job, while pin assignment for the digital I/Os is set in
the device settings.
v2.11.0-B4 44/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®