Timing For Continuous Image Acquisition - Baumer VeriSens ID Series Technical Documentation Manual

13.3 Timing for continuous image acquisition

The sequence of the individual signals and their designation are indicated in the diagram below:
Signal
Exposure time T
2
Image acquisition T
3
Output time (min / max) T
Run-up output T
5
Result retention time T
) 1 Devices with integrated lenses
) 2 Devices with interchangeable lenses
If continuous image acquisition is set in the job, the image acquisition operation occurs as soon as the
previous image acquisition is complete. The Image trigger signal is continuously activated during this time.
The Pass/Fail signal is switched at the end of image analysis but no earlier than the set output time. You can
recognize this time by a rising edge of the Result valid signal.
v2.11.0-B4
35 s
1
Internal illumination
35 s
External illumination
10 µs
2
Flash controller
16 ms
20 ms
4
50 s
6
Full resolution
min. max.
10 ms
/ 10 s
65.5 ms
1 2
1 ms / 65.5 ms
20 ms
2 ms
1 ms 1 s or next
result
265/429
Technical Documentation
VeriSens
Reduced resolution
(device dependant)
min. max.
35 s
5 ms
35 s / 10 s
65.5 ms
1 2
10 s
1 ms
8 ms 11 ms
11 ms
50 s
2 ms
1 ms 1 s or next
result
Baumer Optronic GmbH
Radeberg, Germany
®