Command Dj - Delete Job - Baumer VeriSens ID Series Technical Documentation Manual

15.4.2 Command DJ – delete job
This function enables you to delete some or all of the jobs on the device. The device must be in
Configuration mode for jobs to be deleted.
NOTE
When a power-on job is deleted it will be deleted without replacement!
There is currently no option to insert a new power-on-job via command. Although power-
on jobs can be amended via an update (Command – UJ).
Example
Structure of the command PLC
Command Parameters
D J 0
Delete Job 4 byte ASCII hex
FFFF = all jobs on the device will be deleted
0001 (1) - 00FF (255) = individual jobs on the device will be deleted
Structure of the command PLC
Command Parameters
R J 0
Response 2 byte ASCII hex
Job
0000 = job(s) deleted
0001 = device not in Configuration mode
0002 = invalid job number (job does not exist)
v2.11.0-B4
device
0 0 0
device
0
307/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®