Baumer VeriSens ID Series Technical Documentation Manual page 182


Transition: For each edge, you must specify whether the edge progresses from bright to dark or
from dark to bright.

Minimum contrast: Specify whether you are searching for an edge with sharp or weak contrast.
On the Extended tab, there are further options for influencing the result of the feature check.

The switching points designated Min and Max are adjusted on the right hand side. To do this, the
corresponding criterion must be activated. A graphic display is located in the middle, in which the
positions of the switching points are displayed and where they can be changed.

The button on the right inverts the result of the respective partial check for this feature check.

Minimum distance: Define the criteria for the smallest distance value located.

Maximum distance: Define the criteria for the largest distance value located.

Difference (max. - min. distance): Define the criteria for the difference between the smallest and
largest distance values located.

Greatest difference between adjacent distances: Determine the criteria for the greatest difference
between directly adjacent distances.
Statistics

Mean distance: Define the criteria for the average of all distance values located.

Standard difference: Define the criteria for the standard difference for all distance values located.
v2.11.0-B4 182/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®