Baumer VeriSens ID Series Technical Documentation Manual page 56

Point & point
1. Place the desired target grid with world coordinate system orientation into the Vision Sensor's field of
view. If a SmartGrid is used for this purpose, only the chessboard pattern is used; other information
(reference point, orientation, units) is ignored.
2. Press the Edit button.
3. Select the Point and point method.
4. Now move both reference points to a mark of your choice.
5. Assign coordinates to each of the reference points.
6. Determine the orientation for the coordinate system (left-handed / right-handed).
NOTE
The overlaid coordinate system only specifies the orientations (X,Y) and does not
necessarily show the zero point!
7. Press the Transfer to device button. The programmed coordinates will be transferred to the Vision
Sensor.
v2.11.0-B4 56/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®