Baumer VeriSens ID Series Technical Documentation Manual page 79

The following table explains the meaning of various settings for features and values.
Parameters
Feature Value
Time Image acquisition Provides the time of the image acquisition in milliseconds since the
Result Total result
Result Partial result
Statistics Total result
Statistics Partial result
Trigger Additional data
trigger
Trigger Image counter
NOTE
Following the descriptions of the individual feature checks, there is a table containing the
values which can be output via the process interface.
v2.11.0-B4
Meaning
device was switched on. A 32-bit wide counter (0 - 4294967295) is
used, which starts again at 0 after reaching the maximum.
If this selection is activated, the total result or the partial result of the
job is transferred.
Result (2 characters):
1. Characters: "P" or "F" for a Pass or Fail result
2. Characters: "A" or space for "Alarm triggered" or "No alarm
triggered". 
Partial result (1 character):
"P" or "F" for a Pass or Fail result
"I" if the partial result was not output during the job
If this option is activated, the statistics for the result are included. The
total number of images, the number of OK images and the number of
images for the total result that triggered an alarm are all transferred,
with the individual values separated with a separator.
If this selection is activated, the string transferred via the TD command
is mirrored back as a control option.
If this selection is activated, a 16 bit wide counter (0-65535) is used.
This increases by 1 with each image acquired and resets to 0 once it
reaches 65535.
79/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®