Baumer VeriSens ID Series Technical Documentation Manual page 322

Structure of the command PLC
Command Parameters
S M M
Switch 2 byte ASCII hex
Mode
Mode
For RS485 only
Point-to-
point
protocol
PP
PB
PC
Structure of the Response PLC
Response
R S 0
Response 4 byte ASCII hex
State Status
NOTE
Further explanation of the parameters of the RS response can be found under "Request
status (GS / RS)".
v2.11.0-B4
device
R
Bus
protocol
Protocol mode – Point-To-Point
PP
Changes the employed protocol to point-to-point protocol
Protocol mode – Bus without checksum
PB
Changes the used protocol to bus protocol without checksum
Protocol mode – Bus with Checksum
PC
Changes the used protocol to bus protocol with checksum
device
0 8 5
4 byte ASCII hex
Number of the active job
0 0 1
322/429
Technical Documentation
A
Baumer Optronic GmbH
®
VeriSens
Radeberg, Germany