Baumer VeriSens ID Series Technical Documentation Manual page 11

Technical Documentation
®
VeriSens
NOTE
Networking problems can occur for a number of different reasons, such as power saving
modes on portable computers, defective cables or other defective components, or
incorrect settings on the PC. Should an error occur, contact a technician to locate the
source of the problem.
NOTE
Characters allowed in file names and job names:
0123456789ABCDEFGHIJKLMNOPQRSTUVWXYZabcdefghijklmnopqrstuvwxyz
ÀÁÂÃÄÅÈÉÊËÌÍÎÏ
àáâãäåèéêëìíîï
ÐÑÒÓÔÕÖÙÚÛÜÝß
ðñòóôõöùúûüýÿÇ,
¦!#$%&'+-÷×±,.
¡@_`()[]{}«»~
ATTENTION!
Connection, installation and initial set-up may only be carried out by specialized
personnel.
Protect optical areas from moisture and dirt.
ATTENTION!
The IP protection class is only valid if all connectors are connected as described in the
technical documentation and, for devices with protection class IP 69K, if the sealing screw
on the lens setting opening is correctly screwed in.
ATTENTION!
Disconnection of power to the device during booting can result in damaged files.
Never disconnect the power supply during booting. Booting is finished when intermittent
blinking of the PASS / FAIL – LED or blinking of the POWER LED has stopped.
v2.11.0-B4 11/429 Baumer Optronic GmbH
Radeberg, Germany