General Safety Instructions - Baumer OX200 Operating Manual

Baumer
2.3

General safety instructions

Installation, mounting and adjustment of this product may only be executed by skilled and
n
authorised personnel.
Only use the provided mounting devices and accessories for product installation.
n
Unused outputs must not be assigned. Unused strands must be isolated.
n
Do not exceed the maximum permissible bending radius of the cable.
n
Prior to electrical connection of the product, the system must be down and not live.
n
Where mandatory, use shielded cables for protection against electromagnetic interference.
n
Where plug-in connections are added to shielded cables by the customer, these plug-in con-
n
nections must be EMC compliant and the cable shield must be attached to the connector
housing over a large surface area.
For laser safety reasons, the power supply of this sensor must be switched off when the en-
n
tire plant or machine is switched off.
CAUTION
The sensor has laser class 2.
Never direct the laser at an eye. It is recommended not to direct the beam into empty space but
to stop it with a matt sheet or object.
CAUTION
Release of dangerous laser radiation when the sensor is defective.
Use of the sensor with a fractured front panel or loose/exposed laser optics can release danger-
ous laser radiation.
a) In case of a fractured front panel or loose/exposed laser optics disconnect the laser from the
power immediately.
b) Have the sensor checked by an authorised person (specialist). Do not operate the sensor
until that time.
OX200 | V2 Operating Manual
Security | 2
9