Waveform Generation Function - Renesas M16C/29 Series Hardware Manual

M16C/29 Group

13.5 Waveform Generation Function

Waveforms are generated when value of the base timer matches G1POj register (j=0 to 7).
The waveform generation function has the following three modes :
• Single-phase waveform output mode
• Phase-delayed waveform output mode
• Set/Reset waveform output (SR waveform output) mode
Table 13.5.1 lists registers associated with the waveform generation function.
Table 13.5.1. Registers Related to the Waveform Generation Function Settings
Register
G1POCRj MOD1 to MOD0
IVL
RLD
INV
G1POj -
G1FS FSCj
G1FE IFEj
j = 0 to 7
Bit configuration and function vary depending on which channel is used.
Registers associated with the waveform generation function should be set after setting registers associated with the base time.
Rev.1.00 Nov 01,2004
REJ09B0101-0100Z
Bit
Select output waveform mode
Select default value
Select G1POj register value reload timing
Select inverse output
Select timing to output waveform inverted
Set to "0" (waveform generation function)
Set to "1" (enables function on channel j)
page 154 of 402
13. Timer S (Input Capture / Output Compare)
Function