Table of Contents
Advertisement
M16C/29 Group
1.7 Precautions for Timers
1.7.1 Timer A
1.7.1.1 Timer A (Timer Mode)
1. The timer remains idle after reset. Set the mode, count source, counter value, etc. using the TAiMR
(i = 0 to 4) register and the TAi register before setting the TAiS bit in the TABSR register to "1" (count
starts).
Always make sure the TAiMR register is modified while the TAiS bit remains "0" (count stops)
regardless whether after reset or not.
2. While counting is in progress, the counter value can be read out at any time by reading the TAi
register. However, if the counter is read at the same time it is reloaded, the value "FFFF
Also, if the counter is read before it starts counting after a value is set in the TAi register while not
counting, the set value is read.
3. If a low-level signal is applied to the SD pin when the TB2SC register IVPCR1 bit = "1" (three-phase
output forcible cutoff by input on SD pin enabled), the TA1
high-impedance state.
Rev.1.00 Nov 01,2004
REJXXXXXXX-0100Z
_____
page 10 of 31
_____
, TA2
and TA4
OUT
OUT
OUT
" is read.
16
pins go to a
Advertisement
Table of Contents
