Table of Contents
Advertisement
M16C/29 Group
1.7.2.2 Timer B (Event Counter Mode)
1. The timer remains idle after reset. Set the mode, count source, counter value, etc. using the TBiMR
(i = 0 to 2) register and TBi register before setting the TBiS bit in the TABSR or the TBSR register to
"1" (count starts).
Always make sure the TBiMR register is modified while the TBiS bit remains "0" (count stops)
regardless whether after reset or not.
2. The counter value can be read out on-the-fly at any time by reading the TBi register. However, if this
register is read at the same time the counter is reloaded, the read value is always "FFFF
TBi register is read after setting a value in it while not counting but before the counter starts count-
ing, the read value is the one that has been set in the register.
Rev.1.00 Nov 01,2004
REJXXXXXXX-0100Z
page 15 of 31
." If the
16
Advertisement
Table of Contents
