Honda Accord 2008 Manual page 2546

07/11/02 09:51:50 61TA0000_230_0102
7. Measure the voltage between XM receiver
connector A (14P) terminal No. 1 and body ground.
＊１０
Is there battery voltage?
YES
−
NO
connector E (14P) terminal No. 1 and XM receiver
connector A (14P) terminal No. 1.
8. Reconnect XM receiver connector A (14P).
9. Measure the voltage between XM receiver
connector A (14P) terminal No. 11 and body ground.
＊１１
Is there less than 0.5 V ?
YES
(see page 23-115) and recheck. If the symptom/
indication goes away, replace the XM receiver
(see page 23-115).
−
NO
connector E (14P) terminal No. 11 and XM receiver
connector A (14P) terminal No. 11.
XM RECEIVER CONNECTOR A (14P)
GA ＋ B (WHT)
Wire side of female terminals
− Go to step 8.
Repair open in the wire between audio unit
XM RECEIVER CONNECTOR A (14P)
GA GND (BLK)
Wire side of female terminals
− Substitute a known-good XM receiver
Repair open in the wire between audio unit
Poor or no sound with XM radio (Audio unit
does display XM channels)
NOTE:
• Check the vehicle battery condition first.
• Check the connectors for poor connections or loose
terminals.
• Check the radio reception in an open area. Compare it
to a known-good vehicle whenever possible. Poor
reception/interference can be caused by tall buildings,
mountains, or high-voltage power lines that are
nearby.
• If you can only tune to channel 000, 001, 174, and 247,
make sure that the audio unit is set to the channel
mode (see owner's manual), if it is set to the channel
mode, call XM Satellite Radio customer support and
check the account activation status.
1. Turn the ignition switch to ON (II).
2. Turn on the audio unit and select XM radio.
3. Check for an error message on the display.
Are there any messages displayed?
−
YES Go to error code list (see page 23-57).
NO − Go to step 4.
4. Turn the ignition switch to LOCK (0).
ＴＡ０８ＡＮ３Ｊ１０３００００００００ＦＡＡＴ３１
(cont'd)
23-101 23-101