07/11/02 09:54:06 61TA0000_230_0159
Navigation System
System Description (cont'd)
Navigation Unit Inputs and Outputs
*15
Navigation Unit Connector A (8P)
Terminal
Number
1
2
4
5
6
7
8
23-158
NAVIGATION UNIT CONNECTOR A (8P)
Wire Color
Terminal Name
Description
WHT
+
B
Continuous power
( B Power
+
source
source)
PUR
ACC
Power source for
(Accessory)
accessories
BLK
GND
Ground for
(Ground)
navigation unit
(G605)
LT BLU
BACK LT
Reverse signal of
(Back light or
select lever from
reverse signal)
Multiplex
Integrated Control
Unit (A/T) or
backup light switch
(M/T)
BLU
VSP
Vehicle speed
(Vehicle speed
pulse signal from
pulse)
PCM
RED
DIAG
+
Service check
(Diagnostic
signal for
positive)
navigation system
YEL
DIAG
−
Ground for service
(Diagnostic
check signal
negative)
Wire side of female terminals
Voltage (about)
Battery voltage
If open: Display picture goes out (display back light
still on).
NOTE: System will reboot to enter code screen.
If short to ground: Blows fuse No. 15 (10 A) in the
under-hood fuse/relay box.
Battery voltage
If open: Display picture goes out (display back light
at ACC (I)
still on).
If short to ground: Blows fuse No. 18 (7.5 A) in the
driver's under-dash fuse/relay box.
0 V
If open: No effect on system.
If short to ground: No effect on system.
In reverse,
If open: Navigation never sees reverse.
battery voltage:
Diagnostic screen Car Status, Back=0.
Otherwise 0 V
If short to ground: Blows fuse No. 5 (7.5 A) in the
driver's under-dash fuse/relay box.
0 5 V pulses
−
If open: No vehicle speed pulses.
average 2.5 V
Diagnostic screen Car Status, VSP Navi=0.
(Depending on
If short to ground: No vehicle speed pulses.
bus traffic)
Diagnostic screen Car Status, VSP Navi=0.
5 6 V
−
If open: No effect on system.
If short to ground: System goes into diagnostic
mode at key ON (I) and (II).
0 V
If open: The system will not go into diagnostic
mode when using the SCS jumper.
If short to ground: No effect on system.
Symptom