Honda Accord 2008 Manual page 2617

07/11/02 10:03:20 61TA0000_230_0173
Navigation System
System Diagnostic Mode
Start-up procedure and Diagnostic Menu
There are two ways to enter the diagnostic mode:
1. Start the vehicle and at the globe screen connect
the SCS service connector (see page 23-239) to the
navigation service connector located behind the
navigation unit in the trunk. The sereen changes to
the System Links screen and automatically begins
running the self diagnostic. See the System Links
section for more information.
NOTE: When finished troubleshooting, make sure
to remove the SCS service connector.
＊４１
System Links
Display
R- Camera
GPS Ant.
2. Start the vehicle, and at the disclaimer screen use
the navigation display hard buttons as described
below:
Make sure the battery is in good condition then
press and hold the three buttons (MAP/GUIDE,
MENU, and CANCEL), and keep them pressed for
about 3 seconds. The display screen will go directly
to the Select Diagnosis Items menu shown below.
• Self-Diagnosis Mode (runs the automatic
diagnosis of the navigation system)
• Detail Information & Setting (allows you to
manually diagnose the navigation system)
＊３９
23-172
Help Exit Diag
Radio
XM A/C Meter
Navi.ECU
Error
Car Status Hard Key
History
Yaw
ECU Info. DVD
Sensor
Press any icon if you want to see details.
Select Diagnosis Items Return
Self- Diagnosis Mode
(Navi will check internal function. connections, etc.
Perform this test with vehicle stopped and engine running.)
Detail Information & Setting
(Individual Diagnostic screens to confirm
a specific diagnostic screen.)
System Links
1. Enter this screen by connecting the SCS connector
or by selecting Self Diagnosis Mode from the
navigation screen main menu. The message at the
bottom of the screen flashes indicating the
diagnostic is running. Make sure you enter the
audio anti-theft code.
NOTE:
• The system cannot complete a full diagnosis
unless the engine is runnig.
• DTC 1501 and/or 2703 can be stored when the
ignition switch is at ACCESORY (I). With the
ignition switch is in ACCESORY (I), the A/C unit is
turned off and the navigation unit loses
Return Return
communication and stores DTCs. Therefore,
there is a possibility that the system is normal
even DTC 1501 and/or 2703 is stored. Check
system links with the engine running, and if it
Mic
shows normal, the system is OK at this time.
System Links
HFL
Display
R- Camera
GPS Ant.
2. Rotate the interface dial to select the icon you want
to diagnose. Push in the selector to see the details
of that diagnostic function.
ＴＡ０８ＡＮ１Ｊ３６１００００００００ＦＥＡＴ００
Help Exit Diag Return Return
Radio XM A/C Meter
Navi.ECU
Mic
Error
Car Status Hard Key
History
Yaw
ECU Info. DVD
Sensor
HFL
Press any icon if you want to see details.
＊４２