Honda Accord 2008 Manual page 2600

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:54:05 61TA0000_230_0156

Diagnostic System Diagram

This diagram below shows all of the navigation diagnostic features available for system troubleshooting. The diagram

starts at the center, and works outward in layers.

Access to the diagnostic features begins by starting the vehicle. This is necessary so the system can check the other

systems connected by various busses. After starting the vehicle you can enter the diagnostic mode either by pressing

and holding MENU

The main menu screen allows 2 checking modes - one automatic, and one manual:

• The automatic diagnostic check starts when you select ''SELF DIAGNOSTIC MODE''. The system runs for several

seconds, and reports any issues with Red icons. Rotate the interface dial and select the icon you wish obtain the

problem details.

• The manual diagnostic check is selected from the main menu by selecting ''DETAIL INFORMATION AND SETTING''.

The traditional diagnostic menu is displayed. This allows you to obtain additional details as instructed in the

troubleshooting procedures.

NOTE: Do not clear or change settings unless specified by either the Service Manual troubleshooting procedures or by

the factory. Otherwise, you may accidentally delete customer information, or remove the latest flash software version

installed by the factory.

CANCEL, or by connecting the 2-PIN SCS connector.

Chapters

Table of Contents