Honda Accord 2008 Manual page 2547

07/11/02 09:51:50 61TA0000_230_0103
Audio System
Symptom Troubleshooting (cont'd)
5. Disconnect audio unit connector E (14P) and XM
receiver connector A (14P).
6. Check for continuity between XM receiver
connector A (14P) and body ground according to
the table. Then check for continuity between the
same terminals listed in the table and audio unit
connector E (14P) terminal No. 4 (the harness
shield).
＊０１
Is there continuity?
YES
the XM receiver. Replace the appropriate shielded
harness.
−
NO
23-102
XM receiver connector
A6
A5
A13
A14
XM RECEIVER CONNECTOR A (14P)
Wire side of female terminals
− Short in the wire between the audio unit and
Go to step 7.
7. Check for continuity between XM receiver
connector A (14P) and audio unit connector E (14P)
according to the table.
XM receiver
connector
Wire color
BLK
GRN
WHT
RED
Is there continuity?
−
YES Substitute a known-good XM receiver
(see page 23-115) and recheck. If the symptom/
indication goes away, replace the original XM
receiver (see page 23-115). If symptom/indication is
still present, replace the audio unit (see page
23-109).
NO − Open in the wire between the audio unit and
the XM receiver; replace the appropriate shielded
harness.
Audio unit Wire color
connector
A1 E1
A2 E2
A5 E5
A6 E6
A9 E9
A10 E10
A11 E11
A13 E13
A14 E14
XM RECEIVER CONNECTOR A (14P)
Wire side of female terminals
AUDIO UNIT CONNECTOR E (14P)
Wire side of male terminals
WHT
LT BLU
GRN
BLK
RED
GRN
BLK
WHT
RED
＊０２