Procedure 35 Configuring The Follower Cards - Avaya Nortel Communication Server 1000 Manual

306 Configuration of IP Telephony nodes using Element Manager
Configure the Follower cards
To configure a Follower card, follow the steps in
the Follower cards" (page
Procedure 35
Configuring the Follower cards
Step
1
2
Copyright © 2003–2008, Nortel Networks
.
If any of the Signaling Server IP address information is changed, the
Signaling Server must be rebooted.
Alternatively, restart the card by entering the cardReset command at
the IPL> or oam> prompt or by pushing the Reset button on the card
faceplate.
WARNING
Do not use a pencil to reset the Voice Gateway Media
Card. The graphite carbon can create an electrical short
circuit on the board.
306).
Action
Check the displays on the card faceplate.
• After successfully rebooting, the Leader card is now fully
configured with the node properties of the node. The card enters
a state of "active Leader". The card faceplate display shows
Lxxx, where xxx = the number of IP Phones registered with the
LTPS on the Leader card.
L000 shows that no IP Phones are registered.
• The Follower cards receive their BOOTP configuration
information from the Leader card. The Follower card faceplate
display shows Fxxx, where xxx = the number of IP Phones
registered with the Follower card LTPS.
F000 shows that no IP Phones are registered.
Reboot the Follower card if the card faceplate does not display
FXXX or F000.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
ATTENTION
—End—
Procedure 35 "Configuring