Avaya Nortel Communication Server 1000 Manual page 89

Table 23 "Maintenance Mode commands" (page 89)
used for Maintenance Mode.
Table 23
Maintenance Mode commands
Command
uftpTurboMode
<"HH:MM/start/stop/on/off">, <MM>
<"show">
uftpTurboModeTimeoutSet <MM>
Copyright © 2003–2008, Nortel Networks
.
Enhanced UNIStim Firmware Download for IP Phones 89
Call processing for Signaling Servers operating in normal mode is not
impacted by the firmware download process.
Postponed firmware upgrades are not performed when at least one
Signaling Server is in Maintenance Mode.
Description
Configures Maintenance Mode
"HH:MM" – time to enter Maintenance Mode in 24-hour
format
"start" – enter Maintenance Mode immediately
"stop" – stop Maintenance Mode
"on" – allow Signaling Server to enter Maintenance Mode
"off" – do not allow Signaling Server to enter Maintenance
Mode
MM – optional parameter that defines the length of time in
minutes that Maintenance Mode is to be maintained
"show" – displays the same output as uftpTurboModeShow
If no parameter is entered, Upgrade Manager defaults to
uftpturboMode "start".
Configures the idle timeout timer for Maintenance Mode
MM – optional parameter that defines the number of
minutes the Upgrade Manager waits after the last firmware
download job is started before returning the Signaling
Server to normal mode
If this parameter is configured as 0 (zero), the Upgrade
Manager never exits Maintenance Mode unless the
umsUpgradeModeSet command is issued with the "stop"
parameter.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
lists the commands