Configure Ip Line Data Using Element Manager - Avaya Nortel Communication Server 1000 Manual

Ip line fundamentals
Hide thumbs Also See for Nortel Communication Server 1000:
Table of Contents

Advertisement

274 Configuration of IP Telephony nodes using Element Manager
Read the information about IP network engineering guidelines in Converging
the Data Network with VoIP Fundamentals (NN43001-260) before installing
an IP Telephony node.
Upgrade the ITG-P 24-port line cards to IP Line
CS 1000 systems require the ITG-P 24-port line cards to be running IP Line.
Configure IP Line data using Element Manager
Element Manager can be used to manually add and configure an IP
Telephony node on CS 1000 systems. Multiple nodes can be configured
and managed from Element Manager.
Node definition
A node is defined as a collection of Signaling Servers and Voice Gateway
Media Cards. Each node in the network has a unique Node ID. This Node
ID is an integer value. A node has only one Primary Signaling Server or
Leader Voice Gateway Media Card. All the other Signaling Servers and
Voice Gateway Media Cards are defined as Followers.
All IP addresses and subnet mask data must be in dotted decimal format.
Convert subnet mask data from Classless Inter-Domain (CIDR) format. for
more information, see
Dotted Decimal Format" (page
See
(page 233)
The following sections discuss how to configure IP Line using Element
Manager. The following three sections found in the IP Telephony section of
Element Manager are not covered in this NTP:
Copyright © 2003–2008, Nortel Networks
.
WARNING
In CS 1000 systems, TM 3.1 is required to upgrade an ITG-P
24-port line card running IP Line 2.2 (or earlier) to IP Line.
After the card software is upgraded to IP Line using TM 3.1,
configuration, administration, and maintenance tasks can be
performed using Element Manager.
See ITG-P 24-port card upgrades in Communication Server 1000E
Upgrade—CS 1000M Cabinet to CS 1000E (NN43041-466) or
Communication Server 1000E Upgrade—CS 1000M Chassis to
CS 1000E (NN43041-467) for the procedure to upgrade an ITG-P
24-port line card to IP Line software.
Appendix "Subnet Mask Conversion from CIDR to
Table 70 "Voice Gateway Media Card installation summary sheet"
for IP addresses and information required in this procedure.
SNTP (see IP Peer Networking Installation and Commissioning
(NN43001-313)
NRS (see IP Peer Networking Installation and Commissioning
(NN43001-313)
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
545).

Advertisement

Table of Contents
loading

Table of Contents