Avaya Nortel Communication Server 1000 Manual page 341

4
5
6
Copyright © 2003–2008, Nortel Networks
.
Configure the password, first with a null password and then with a
password specified.
Type nodePwdSet at the IPL> prompt.
Note that no password parameter is specified.
Type nodePwdShow to see the following:
NodeID PwdEna Pwd
====== ======= ======== ======== ======= ===========
123 No
PwdEna – the password is now enabled (PwdEna=Yes).
Pwd – if no <"password"> parameter specified, the administrator
password is null. IP Phones cannot be installed when the password
is null. A null password causes the node ID and Password screen to
be skipped during restart.
WARNING
The nodePwdSet command, with no parameter, by
default enables the administrator password and sets a
null (zero-length) password.
IP Phones cannot be installed if the administrator
password is enabled and set to null.
Always specify the password parameter to install IP
Phones.
Type nodePwdSet <"password"> at the IPL> or oam> prompt,
where the password parameter is 6 to 14 digits in length.
The valid character are 0-9 * #. For this example, use "1234567" as
the password.
Type nodePwdShow to see the following:
NodeID PwdEna
Uses Timeout ======
======== =======
1234567
PwdEna – the administrator password is enabled (PwdEna=Yes).
Pwd – the administrator password, 1234567, is displayed.
Always specify the <password> parameter when entering the
nodePwdSet command.
The nodePwdEnable and nodePwdDisable commands enable
and disable the administrative IP Phone Installer Password,
respectively.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
TmpPwd Uses
0d 0h 0m 0s
Pwd TmpPwd
======= ========
=========== 123
od 0h 0m 0s
Password security 341
Timeout
No