Procedure 54 Restarting A Voice Gateway Media Card At The Cli - Avaya Nortel Communication Server 1000 Manual

If IP addresses that affect the entire node are changed, all cards in the node must
be restarted. See
Changes to the SNMP trap destination IP addresses take place immediately
when the transfer occurs; restarting the cards is not required.
If the IP address of a Voice Gateway Media Card has changed, restart only
that card.
Follow the steps in
at the CLI" (page 407)
Voice Gateway Media Card can be restarted from within Element Manager.
Follow the steps in
in Element Manager" (page 408)
Procedure 54
Restarting a Voice Gateway Media Card at the CLI
Step
1
2
3
Copyright © 2003–2008, Nortel Networks
.
"Restart all the Voice Gateway Media Cards" (page
Procedure 54 "Restarting a Voice Gateway Media Card
to restart a specific card using the CLI. Alternatively, a
Procedure 55 "Restarting a Voice Gateway Media Card
Action
To prevent interruption to the speech path, log into LD 32.
Type the DISI command.
This command disables the voice gateway channels when they
become idle. DISI removes the call traffic but does not remove the IP
Phones that are registered on that Voice Gateway Media Card. The
Graceful TPS Disable command disiTPS removes the registered
IP Phones.
Type disiTPS at the card IPL> or oam> prompt to disable the LTPS
service on the Voice Gateway Media Card.
This Graceful TPS Disable command prevents new IP Phones from
registering on the card. All IP Phones registered on the card are
redirected to another Voice Gateway Media Card when the IP Phone
becomes idle.
After the command is entered, an idle IP Phone should be updated
with the Watchdog reset message. However, the LTPS sends a soft
reset message to the IP Phone, redirecting it to the Connect Server.
The disabled LTPS does not accept new registrations, so the IP
Phones must register with another LTPS in the node. Eventually,
as all of the LTPS IP Phones become idle, they are registered with
other TPS. The Voice Gateway Media Card can then be removed
with no impact to any users.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Update IP Telephony node properties 407
ATTENTION
to restart the card using Element Manager.
408).