Avaya Nortel Communication Server 1000 Manual page 76

76 Features
Command
usiSetPhoneRudpTimeout
usiGetPhoneRudpTimeout
If the customer has a network with low network delays, one or both parameters can be reduced to
make an IP Phone more responsive to failures. If the network delay values are high, the parameters
can be increased to prevent the IP Phones from being reset due to significant network delay.
The RUDP Timeout and Retries Count commands are found in the usi
group. If Help is typed at the OAM prompt, the following is output.
oam> help
For help on a particular command group type:
Available command groups are:
......
DLOG
usi
vte
commands
The configured values are saved in the [usiLib] section of the TPS.ini file
and downloaded to all UNiStim IP Phones registered to the Signaling Server
or Voice Gateway Media Card where the value was configured. When a
supported IP Phone registers with the Signaling Server or Voice Gateway
Media Card, the IP Phone downloads the new values.
It is necessary to configure these values on every Signaling Server and
Voice Gateway Media Card in the node.
Overlay and command modifications
Because call failover is an exceptional situation, ACF information is output
only if it exists.
Status definitions
UNREG
The ACF call is UNREGISTERED (UNREG). This occurs when both parties
go offline. This state is always monitored by the 10-minute ACF timer. The
call is released if the Call Server ACF timer expires.
Copyright © 2003–2008, Nortel Networks
.
Description
Configure the RUDP Timeout value (in ms) for
IP Phones
50 – (500) – 1000 in increments of 50
milliseconds
Display the RUDP Timeout value (in ms) for IP
Phones
f/w download log file commands
UNISTIM related commands
Virtual Terminal Emulator related
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
help 'group'