Avaya Nortel Communication Server 1000 Manual page 283

SNMP configuration
For more information about SNMP, see Communication Server 1000 Fault
Management—SNMP (NN43001-519).
Configuring SNMP trap destinations and community strings
IP Line introduces single point configuration for SNMP traps. To
configure the SNMP trap destinations, and community strings for the
Call Server, Signaling Server, Voice Gateway Media Cards, and Media
Gateway Controller in Element Manager, follow the steps in
"Configuring SNMP trap destinations" (page
It is necessary to perform a datadump to save the configuration information
permanently whether the parameters are configured in Element Manager or in
LD 117.
Copyright © 2003–2008, Nortel Networks
.
Configure IP Line data using Element Manager 283
c. Embedded LAN (ELAN) gateway IP address: Enter the
Embedded LAN (ELAN) subnet gateway IP address in dotted
decimal format. This is the IP address of the gateway of the
subnet to which the Voice Gateway Media Card belongs. Also,
this is the IP address of the router interface on the ELAN subnet,
if present. If there is no Embedded LAN subnet gateway, enter
0.0.0.0.
d. Embedded LAN (ELAN) subnet mask: Enter the Embedded
LAN (ELAN) subnet mask address in dotted decimal format.
This is the subnet mask that is used along with the ELAN subnet
IP address to identify to which subnet the Voice Gateway Media
Card belongs.
e. Voice LAN (TLAN) subnet mask: Enter the Voice LAN (TLAN)
subnet mask address in dotted decimal format. This is the subnet
mask that is used along with the TLAN IP address, to identify the
subnet to which the Voice Gateway Media Card belongs.
Do not click Save and Transfer until all the node information has
been entered. If the Submit button is clicked prematurely, the Node
Configuration window reappears. If Save and Transfer was clicked
prematurely, click the Edit button to return to the Node Edit window and
continue the configuration.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
ATTENTION
—End—
284).
ATTENTION
Procedure 25