Avaya Nortel Communication Server 1000 Manual page 449

Command Description
Enable the specified card, where: l = loop, s = shelf, c = card
ENLC l s c
Enable the specified unit, where: l = loop, s = shelf, c = card, u = unit
ENLU l s c u
Print the Card ID information for the specified card,
IDC l s c
where: l = loop, s = shelf, c = card
This command displays the PEC (Product Engineering Code) and serial
number for the card. The IP Line PEC is NTZC80AA.
Print the CS 1000 software status of the specified card,
STAT l s c
where: l = loop, s = shelf, c = card
Print the CS 1000 software status of the specified unit,
STAT l s c u
where: l = loop, s = shelf, c = card, u = unit
LD 117
Table 126 "LD 117 Count registered IP Phones" (page 449)
system maintenance commands available in LD 117.
The following ECNT commands are also maintained in LD 32:
•
•
•
•
For more information about the ECNT commands, see
Phones" (page
Table 126
LD 117 Count registered IP Phones
Command
ECNT CARD L S C
<customer>
Copyright © 2003–2008, Nortel Networks
.
IP Line and IP Phone maintenance and diagnostics 449
ECNT CARD <Loop> <Shelf> <Card> <CustomerNumber>
ECNT NODE <NodeNumber>
ECNT SS <HostName>
ECNT ZONE <ZoneNumber> <CustomerNumber>
169).
Description
Counts and prints the number of IP Phones registered for the
specified card.
• If the <customer> parameter is specified, the count is specific to
that customer. A card must be specified to enter a customer;
otherwise, the count is across all customers.
• If no parameters are entered, the count is printed for all zones.
A partial TN can be entered for the card (L or L S) which then
prints the count per that parameter. A customer cannot be
specified in this case.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
summarizes the
"Counting IP