Avaya Nortel Communication Server 1000 Manual page 558

558 Appendix F Moving Voice Gateway Media Cards between systems
3
4
5
6
Command
BIOS>lnIsa_progIP
BIOS>lnIsa_progSubnetMask
BIOS>lnIsa_ProgGW
7
8
9
Copyright © 2003–2008, Nortel Networks
.
At the prompt, to escape to BIOS VxWorks, enter
jkl
To change the ELAN IP address configuration, the IP Telephony
application Leader flag, and the IPL> logon parameters in NVRAM,
enter
BIOS>nvramClear
The card becomes a Follower; the Leader flag is cleared, and the
IP telephony parameters are reset to the default values of the logon
account.
To set the flag so the ELAN IP address configuration data is read
from the NVRAM instead of a BootP query, enter
BIOS>lnIsaIPMethodSet 2
At the prompt, enter
Every node must have a Leader. To set the Leader flag for the ITG-P
24 port card, enter
BIOS>nvramLeaderSet
You reformat the C drive. The C drive is formatted the next time
the ITG-P 24-port card restarts (after the sysReboot command).
Reformatting the C drive deletes all existing configuration files,
syslog files, and OM report logs on the ITG-P 24 port card.
To reformat the C drive and to remove the configuraton files the next
time the card restarts, enter
BIOS>reformatCdrive
BIOS>sysReboot
After the sysReboot command is executed, the Voice Gateway Media
Card restarts and the following default user name and password is
available for CS 1000 Release 4.0 and lower:itgadmin, itgadmin
itgadmin, itgadmin
Use standard procedures to upgrade Voice Gateway Media Card
8051XA Controller firmware and the software, if necessary.
To upgrade the software for the ITG-P 24-port card, see
the software" (page
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Description
ELAN IP Address
ELAN subnet mask
ELAN Gateway IP address
562).
"Upgrading