Procedure 76 Removing An Nt8D81Ba Cable - Avaya Nortel Communication Server 1000 Manual

Replace the NT8D81BA cable with the NT8D1AA cable and install the NTCW84JW special IPE
Procedure 76
Removing an NT8D81BA cable
Step
1
2
3
4
5
6
7
Install the NTCW84JA filter and NT8D81AA cable
Follow the steps in
NT8D81AA cable" (page 539)
cable.
Procedure 77
Installing an NTCW84JA filter and NT8D81AA cable
Step
1
2
Copyright © 2003–2008, Nortel Networks
.
Action
Identify the I/O panel and backplane designation that corresponds to
the LEFT slot of the pair of card slots, viewed from the front, in which
the ITG ISL Trunk card is installed.
Disconnect the filter from the I/O panel using a screwdriver and
needle nose pliers. Retain the fasteners.
Power down the IPE shelf.
Remove the IPE module I/O safety panel.
To remove the ribbon cables from the IPE backplane, apply gentle
pressure on the tab on the right side of the shroud while pulling on
the connector until it pulls free from the shroud.
Remove connector 1 first, then remove connectors 2 and 3.
Discard the NT8D81BA cable.
Procedure 77 "Installing an NTCW84JA filter and
Action
Install the NTCW84JA special IPE filter connector in the vacant I/O
panel slot using retained hardware.
Install the NT8D81AA ribbon cable connectors in the IPE module
backplane shroud. Be sure to install the connector so the label is
facing right with the arrow pointing up and the connector is fully
engaged into the shroud:
a. Install connector 1, (labeled UP1^) into backplane shroud 1.
b. Install connector 2, (labeled UP2^) into backplane shroud 2.
c. Install connector 3, (labeled UP3^) into backplane shroud 3.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
—End—
to install the NTCW84JA filter and NT8D81AA
filter 539