Avaya Nortel Communication Server 1000 Manual page 253

6
Configure VoIP bandwidth management zones (LD 117)
Up to 256 zones can be defined in LD 117. The Call Server uses the zones
for VoIP bandwidth management. For more information, see Converging the
Data Network with VoIP Fundamentals (NN43001-260).
The term Intrazone means within the same zone. Interzone means between
two different zones.
Table 76 "LD 117 bandwidth management zone configuration" (page
254)
•
•
•
•
•
LD 117 also includes the DIS and ENL commands to disable or enable a
zone. When a zone is created, its default state is enabled.
Copyright © 2003–2008, Nortel Networks
.
Go to LD 137. Check the status of the Ethernet network interface by
entering the command: STAT ELNK. If the ELNK network interface
is disabled, enable it by entering: ENL ELNK.
lists the zone parameters as follows:
p1 – total bandwidth (kb/s) available for Intrazone calls
p2 – defines the codec for Intrazone calls (that is, preserve voice quality
or preserve bandwidth). BQ provides the best voice quality but uses the
most bandwidth. BB uses the least amount of bandwidth but reduces
voice quality.
p3 – total bandwidth available for Interzone calls
p4 – preferred strategy for the choice of the codec for Interzone calls
p5 – zone resource type. The type is either shared or private.
For information about Private Zone configuration, see
configuration" (page
CAUTION
Zone 0 must be configured in LD 117 first before other zones are
configured or all calls associated with zone 0 are blocked.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Initial configuration of IP Line data 253
—End—
178).
"Private Zone