Troubleshoot An Ip Phone Installation - Avaya Nortel Communication Server 1000 Manual

490 Voice Gateway Media Card maintenance
Work with alarm and log files
Alarm and log file output is turned on using the IPL> CLI. The following
commands can be performed at the IPL> prompt:
•
•

Troubleshoot an IP Phone installation

If an IP Phone cannot be installed because the prompt for the node ID or
TN does not display, follow the steps in
IP Phone installation" (page
Procedure 67
Troubleshooting an IP Phone installation
Step
1
2
3
4
Copyright © 2003–2008, Nortel Networks
.
DSPSndLpbkTestOn ("DSPSndLpbkTestOff" to stop the test)
DSPRcvLpbkTestOn ("DSPRcvLpbkTestOff" to stop the test)
The DSPs and all associated ports must be disabled before performing
these tests.
To turn on or turn off the error log file, type: logFileOn or logFileOff.
To display the modes of all log files and alarms, type: logFileShow.
Action
Log into one Signaling Server or Voice Gateway Media Card in the
node.
Type the nodePwdShow command at the IPL> or oam prompt.
If the administrative password is enabled (PwdEna=Yes) and there
is a null (zero-length) password (the Pwd field is blank), then the IP
Phone cannot be installed on that Voice Gateway Media Card.
Nodel PwdEn
====== d
======= == 0d 0h 0m 0s =
Use the nodePwdSet "password" command to set the
administrative password and to enable IP Phones to be installed.
Ensure the "password" parameter is included.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
ATTENTION
Procedure 67 "Troubleshooting an
490).
Pwd TmpPw Uses
===== ========== =====
—End—
Timeout D a
===== ==
== == 123 Yes