Avaya Nortel Communication Server 1000 Manual page 463

Table 130
Configuration commands
Command
NVRIPSet
NVRGWSet
NVRSMSet
NVRIPShow
NVRClear
nvramLeaderSet
nvramLeaderClr
setLeader
clearLeader
tLanDuplexSet
tLanSpeedSet
Reset commands
Table 131 "Reset commands" (page 463)
commands. For more information about reset commands, see Software
Input Output Reference—Maintenance (NN43001-711).
Table 131
Reset commands
Command
cardReset
isetReset "tn"
Copyright © 2003–2008, Nortel Networks
.
Description
Configures the IP address in NVRAM.
Configures the default gateway address in NVRAM.
Configures the subnet mask in NVRAM.
Prints the values of the IP parameters that reside in
NVRAM.
Clear IP parameters in NVRAM.
Configures the Leader bit in NVRAM.
Clears the Leader bit in NVRAM, but does not erase the
IP parameters in NVRAM.
Configures a Leader card, including the IP address,
gateway, subnet mask, boot method to static, and Leader
bit in NVRAM. This one command does all the necessary
actions to make a Leader.
Clears the Leader information in NVRAM, sets the
boot method to use BOOTP, and removes the old
configuration files. This command makes a Leader card
into a Follower card.
Configures the TLAN Ethernet duplex mode.
This command does not appear on the MC 32S card.
Configures the TLAN Ethernet speed.
This command does not appear on the MC 32S card.
Description
Resets a Voice Gateway Media Card.
This command performs a warm reboot
of the Voice Gateway Media Card. The
card must be in the OOS state to use
this command.
Where tn is l s c u
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
IP Line CLI commands 463
lists the Reset IPL> and oam>
Signaling
Server
X
Signaling
Server