Avaya Nortel Communication Server 1000 Manual page 130

130 Features
If a PVQM command is entered with an IP address that multiple IP Phones
are using, then an error message is also printed.
WARNING: There are 2 IP Phones that use the public IP address
of 47.11.217.102
These PVQM commands include:
•
•
•
•
•
•
•
•
•
•
echoServerShow
The echoServerShow command provides both configuration information
about the Echo Servers and information about interactions with the Echo
Servers for the IP Phones on a specific LTPS. Use this command on an
LTPS card to investigate a problem with an IP Phone registered to that
LTPS card. This is a per-card command that provides information about
the Echo Servers from the viewpoint of the LTPS on the card where the
command is entered.
The command has one optional parameter, "action"; the only valid value is
99. When echoServerShow 99 is entered, the counter values are reset
after they are displayed. When just echoServerShow is entered, the
counter values are displayed without being reset.
The output for each Echo Server displays the following information:
•
•
Copyright © 2003–2008, Nortel Networks
.
RTPStatShow
RTPTraceShow
RTPTraceStop
rPing
rPingStop
rTraceRoute
rTraceRouteStop
eStatShow
RUDPStatShow
isetInfoShow
Configured – the IP address: port configured for this Echo Server in
LD 117
Actual – the IP address: port used for this Echo Server, followed by
an explanation in parenthesis. This is different from the "Configured"
parameter only when the default address (0.0.0.0) has been configured.
The explanation in parenthesis is one of the following:
— (TLAN IP, this card) – the IP address used is the TLAN network
interface of this card; the Echo Server is active on this card.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008