Appendix B I/O, Maintenance, And Extender Cable Description531; Connector Pin Assignments - Avaya Nortel Communication Server 1000 Manual

532 Appendix B I/O, maintenance, and extender cable description
The NTMF94EA cable provides a factory-installed, shielded, RJ-45-to-RJ-45
coupler at the end of both the ELAN and the TLAN network interfaces. An
unshielded coupler is provided to prevent ground loops (if required). See
"Prevent ground loops on connection to external customer LAN equipment"
(page
ends of the RJ-45 ports of the cables are labeled to distinguish the TLAN
network interface and the ELAN network interface. The ports provide the
connection point to the customer ELAN and TLAN equipment. Use shielded
CAT5 cable to connect to the customer equipment.
To improve EMC performance, use standard cable ties to bundle all LAN
cables as they route out of the system.
To avoid damage to CAT5 cable, do not overtighten cable ties.
Figure 108
NTMF94EA ELAN, TLAN and RS-232 serial maintenance I/O cable

Connector pin assignments

Table 148 "Voice Gateway Media Card I/O Panel Pinout" (page 533)
the I/O connector pin designations for the Voice Gateway Media Card.
Copyright © 2003–2008, Nortel Networks
.
534), to determine if the unshielded coupler should be used. Both
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
ATTENTION
shows