Avaya Nortel Communication Server 1000 Manual page 459

For more information about file transfer commands, see Software Input
Output Reference—Maintenance (NN43001-711).
Table 129
File Transfer commands
Command
swDownload
"hostname",
"username",
"password",
"directory path",
"file name"
configFileGet
"hostname",
"username",
"password",
"directory path",
"file name"
Copyright © 2003–2008, Nortel Networks
.
Description
Loads a new version of software from the FTP
host to the Voice Gateway Media Card.
Updates the software on the Voice Gateway
Media Card with the binary file received from an
FTP server corresponding to the hostname IP
address. The Voice Gateway Media Card FTP
client performs a Get which downloads the file to
the flash bank. A checksum is calculated to verify
correct delivery. After the new software version
is successfully downloaded, the Voice Gateway
Media Card must be rebooted with cardReset to
run the new software.
Hostname refers to the either IP address of the
FTP host, or the Voice Gateway Media Card itself
or another Voice Gateway Media Card when a
PC Card in the /A: drive of the Voice Gateway
Media Card contains the software binary file.
Example:
IPL> swDownload "47.82.32.346", "anonymous",
"guest", "/software", "VxWorks.mms"
Sends an updated CONFIG.INI file from TM to
the Voice Gateway Media Card.
Updates the CONFIG.INI file on the Voice
Gateway Media Card with the CONFIG.INI file
on the specified host, account, and path. The
configFileGet task on the ITG host initiates
an FTP session with the given parameters
and downloads the file to flash file system.
The CONFIG.INI file also contains the NRS
IP address, gateway password, and gateway
DN-port mapping table.
Example:
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
IP Line CLI commands 459
Signaling
Server
X
X