Ip Configuration Commands - Avaya Nortel Communication Server 1000 Manual

344 IP Line administration
4
5
6
7
IP configuration commands
Table 90 "IP configuration commands" (page 344)
configuration commands.
Table 90
IP configuration commands
IP configuration command
setLeader
clearLeader
NVRIPShow
Copyright © 2003–2008, Nortel Networks
.
WARNING
Do not use a pencil to reset the Voice Gateway Media
Card. The graphite carbon can create an electrical short
circuit on the board.
Start up messages are displayed on the terminal. Type jkl on the
terminal keyboard when the prompt is displayed.
jkl runs from BIOS or boot ROM which is printed early in the
bootup process. There is only a six second window at the prompt
to enter jkl. If the prompt is missed, restart the card and repeat
the above step.
After the card has booted from BIOS or boot ROM, a CLI prompt
such as the BIOS> appears. Enter the following command:
shellPasswordNvramClear at the prompt.
Type reboot at the prompt to reboot the card.
Wait for the card to completely reboot into the IP Line application.
The password synchronization feature changes the password on the
card automatically.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
—End—
describes the IP
Function
Performs all the necessary actions to make
a Leader. Sets IP address, gateway, subnet
mask, boot method to static, and Leader bit in
NVRAM.
Clears the Leader info in NVRAM and sets the
boot method to use BOOTP, thus, making the
card a Follower.
Prints the values of the IP parameters that
reside in NVRAM.