Counting IP Phones
The commands to count registered IP Phones are available in LD 32 and
LD 117.
Commands in LD 117 are as follows:
•
•
•
Previously, all ECNT commands were in LD 32. The following existing LD
32 ECNT commands are now duplicated in LD 117 to maintain a consistent
interface. However, they continue to be maintained in LD 32 as well.
•
•
•
•
Table 50 "LD 117 commands to count registered IP Phones" (page
169)
Table 50
LD 117 commands to count registered IP Phones
Command
ECNT CARD L S C
<customer>
Copyright © 2003–2008, Nortel Networks
.
ECNT FW <XX> <A> <BB> <FF> – count the number of IP Phones with
specified firmware ID and, optionally, firmware version.
ECNT MODL <MMMM> – count the number of IP Phones of the
specified model>. If the MMMM parameter is omitted, the IP Phone
Model Names and their associated mnemonics are listed.
ECNT PEC <PEC> – count the number of IP Phones with a specified
Product Engineering Code (PEC).
ECNT CARD <Loop> <Shelf> <Card> <CustomerNumber>
ECNT NODE <NodeNumber>
ECNT SS <HostName>
ECNT ZONE <ZoneNumber> <CustomerNumber>
describes these commands.
Description
Counts and prints the number of IP Phones registered for the
specified virtual card.
•
If the <customer> parameter is specified, the count is specific to
that customer. A card must be specified to enter a customer;
otherwise, the count is across all customers.
•
If no parameters are entered, the count is printed for all zones. A
partial TN can be entered for the card (L or L S) which then prints
the count per that parameter. A customer cannot be specified in
this case.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Call Statistics collection 169