Procedure 44 Resetting The User Name And Password To Default - Avaya Nortel Communication Server 1000 Manual

Default user name and password
The IPL> CLI has a default user name of admin1 and a default password
of 0000. The default user name and password must be changed as a
preventative security measure. The shellPasswordSet command changes
the IP Line username and password. But because the password is
synchronized with the Call Server, Nortel recommends you change the
PWD1 password.
Reset the CLI Shell user name and password
If the authorized system management personnel do not have the current
IPL> CLI Shell user name and password, reset the user name and password
to the default (admin1 and 0000).
To reset the IPL> CLI shell user name and password, follow the steps in
Procedure 44 "Resetting the user name and password to default" (page
343). This procedure requires a connection to the local maintenance port
on the Voice Gateway Media Card and also requires rebooting the card,
which interrupts services.
Procedure 44
Resetting the user name and password to default
Step
1
2
3
Copyright © 2003–2008, Nortel Networks
.
NodeID PwdEna
Uses Timeout ======
======== =======
1234567
Action
Connect a terminal to the Maintenance port (labeled Maint) either
directly or through a dial-up modem. The terminal communication
parameters must be as follows:
• 9600 bps
•
8 data bits
• no parity
• 1 stop bit
Press the Enter key on the keyboard.
The logon: prompt is displayed.
Reboot the card by pressing the RESET button on the faceplate of
the card with a pointed object, such as a ball-point pen.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Pwd TmpPwd
======= ========
=========== 123
0d 0h 0m 0s
—End—
Password security 343
No